Uptown: Door Knobs

Way back in July when I took possession of my new home, I had thought that one of the quickest changes I was going to make was to change the door knobs. I could have taken an easy way out and just replaced the actual key lock part of the knob but the existing knobs were old and so I thought it would be wise (and straightforward) to replace them completely.

door-knob-5

old knobs

The task started off quite well. I used the measuring guide on the Direct Door Hardware website and the kind people over at Direct Door Hardware sent over some simple, stainless Schlage knobs and matching locks.door-knob-1

 determining the backset

door-knob-3

the new Schlage knob & deadbolt

I thought the job was going to take half an hour (tops!). My dad and I took out the old knobs in one of the doors and that’s when we realized that the new Schlage sets would not fit because the bore hole in my door was too small for the lock sets (didn’t think to measure that before I ordered the locks). This was the case for all the doors. I was pretty disappointed. After a bit of research I learned that it would be unlikely to find high quality locks to fit the small bore holes. Plus, I really wanted to use the new stainless sets.

door-knob-4

oops…too small!

I went back to the Direct Door Hardware people for advice (thanks Jake E.!) and thought about my options. I was reluctant to let the knobs go to waste so I decided to hire a locksmith to cut new bore holes in all my doors. I didn’t tackle this task on my own as, in addition to having metal doors, I didn’t have the appropriate tools, and I was too impatient to try measuring anything out by myself. It’s good to admit when you need help, right? Something like that.

door-knob-6

the locksmith’s high-tech tool

doorknob1

new knobs (pre-paint)doorknob2new knobs & locks

Anyway. I’m happy to report that the door knobs and locks are in throughout my house and they are working out perfectly. I’m happy with the strength and simplicity of the set I ordered, and the service at Direct Door Hardware was quick and informative. I’m also happy that I decided to hire the locksmith to get the bore holes to a standard size. This will give me more flexibility later on if I decide to install another new set.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.